Dreambox 500T Satellite Receiver Specifications

DreamBox 500T Terrestrial Receiver Features:
1)250 MHz IBM PowerPC Processor(350 Mips)
2) Linux Operating System
3)1 x Smartcard-Reader
4) MPEG2 Hardware decoding
5)100Mbit full duplex Ethernet Interface
6)2 LED status
7) Unlimited channel lists for TV/Radio
8) channel-change time < 1 second
9) Full automatic service scan
10) Supports directly bouquet-lists(indirect unlimited)
11) Supports EPG(electronic program guide)
12) Supports multiple LNB-Switching control(supports DiSEqC)
13) Fully adaptable OSD in many languages(skin-support)
14) SPDI/F Interface for digital bit stream out(AC-3/DTS)
15)1x Scart-interfaces(fully controlled by software)

DreamBox 500T Terrestrial Receiver technical data:

DreamBox 500T Terrestrial Receiver DBS-Tuner:
Frequency Range 950 .... 2150 MHz
Signal Level - 65 dBm .... - 25 dBm
Signal-to-Noise Level 12 dB max.
DBS-Tuner Input Connector F-Type female
Input Impedance 75 Ohm
AFC +/- 3 MHz
Demodulation Shaped QPSK
Input Symbol rate 2 .... 45 Mbaud/s,SCPC/MCPC
FEC Viterbi and Reed-Solomon
Viterbirate 1/2,2/3,3/4,5/6,7/8,automatic assimilation
Roll-off Factor 35%
Demultiplexing according ISO 13818-1
Video decoder:
Video Compression MPEG-2 and MPEG-1 compatible
Video Standard PAL G/25 Hz
Video Formats 4:3/16:9
Footage 16:9,automatic assimilation for 16:9 TV-Device(over Scart)
Letterbox precolating for 4:3 TV-Device
Audio decoder:
Audiokompression MPEG-1 & MPEG-2 Layer I and II
Audio Mode Dual (main/sub),Stereo
Frequency:32kHz,44.1kHz, 48 kHz,16kHz,22.05kHz,24kHz
Output analog:
Output Level L/R 0.5Vss on 600Ohm
THD >60dB(1kHz)
Crosstalk<-65dB
Output digital:
Output Level 0.5Vss on 75Ohm
Sampled Data Filtering 32kHz,44.1kHz,48kHz
S/PDIF-Output optical(AC3)
Video parameter:
Input Level FBAS 1 Vss +/- 0.3dB on 75Ohm
Teletext filter in conformity with ETS 300 472 Standard

DreamBox 500T Terrestrial Receiver TV-Scart:
Output: FBAS,RGB,S-VHS over OSD selectable
Serielle Interface RS 232:
Typ RS232 bidirectional
Bit rate 115,2 kBit/s max.
Plug Connector SUB-D-9
Function Update of Firmware and Preprogramming
Ethernet:
100 MBit compatible, bi-direktional interfaces
Function Update of Firmware and Preprogramming
LNB Power and polarisation:
LNB Current 500mA max. ; short-circuit-proof
LNB Voltage vertical < 14V without load,>11.5V at 400mA
LNB Voltage horizontal < 20V without load,>17.3V at 400mA
LNB shut-off at Standby-Mode
Count of active satellite position:
DiSEqC 1.0/1.2 SAT POSITION/SAT OPTION
DiSEqC - Rotor Control
Power consumption:
<10W/12V
Input voltage:
DC12V,alternating acurrent +/- 15%
Extern power supply:
Input:
110-240V AC/50-60Hz/0.6A
Output:
12V =/1A
Others:
Ambient Temperature +15Cxxxxx+35C
Humidity < 80%